玻璃盤360度牙傷光學篩選機
Optical screening machine for teeth injury of glass plate in 360 degrees
HL-05-360-LSLM
參數規格
Specifications
本機臺外觀尺寸：
約2300mm*1200mm*2300mm(長*寬*高)
機臺重量：約750KG
更換規格：約10分鐘
檢測范圍：
長度:10-60MM 直徑：5-25mm （可以倒立）
速度最快可達600支/分鐘
本機臺為檢測螺栓、螺帽一體機
最多可裝8支CCD
電源：交流單項220V 50HZ
功率：約3KW
The appearance size of this machine:
About 1200mm*1200mm*2300mm (length*width*height)
Machine weight: about 750KG
Replacement specification: about 10 min
examination range:
Length: 10-60mm Diameter: 5-25mm (can be inverted)
The fastest speed:600 / min
This machine is a testing bolt and nut integrated machine
Up to 8 CCDs
Power: AC single 220V 50HZ
Power: about 3KW
可檢測項目
Suitable for
○外螺紋360度牙傷檢測；○螺紋直徑公差檢測；
○最大/最小對邊公差檢測；○有無印記檢測；
○螺紋牙底徑檢測；○最大/最小對角公差檢測；
○螺紋牙中徑檢測；○內孔與外圓同心度檢測；○牙距檢測；
○內孔徑有無毛刺檢測；○有無螺紋檢測；
○頭部有無電鍍檢測；○斜牙檢測；○頭部表面開裂；
○粗細牙檢測；○內孔直徑公差；○尖銳度檢測；
○有無焊點，及焊點數檢測；○頭部真圓度測量；
○焊點面積檢測；○搓牙有無到位檢測；○牙數檢測；
○螺帽牙內有無鐵屑檢測；○各部位臺階公差檢測；
○梅花形狀及有無滾花檢測；○頭部厚度公差檢測；
○螺帽爛牙、壞牙檢測（可360度檢測）；○總長度公差檢測；
○Thread diameter tolerance detection;○Maximum / minimum alignment tolerance detection;○Threaded teeth bottom diameter detection; ○Maximum/minimum diagonal tolerance detection;○Thread middle diameter detection; ○Concentricity detection of inner hole and outer circle; Distance detection between teeth;
○Detection for burr in internal aperture or not; ○Thread or not;
○Electroplating on head or not;○ Oblique teeth detection; Head surface cracking;
○Teeth thickness detection;○ Diameter tolerance of inner hole;○ Sharpness detection;○Detection for solder joint or not and the number;○Head roundness measurement;○Solder joint area detection;○Detection for rub teeth in place or not;○Teeth number detection;○Detection for iron chip in nut teeth or not;○ Step tolerance detection of each part;○Detection of plum blossoms and annular knurl or not; ○Head thickness tolerance detection;○Detection for broken teeth and bad teeth of nut (360 degree detection);○Total length tolerance detection;
